No, you don’t need any special tools. The installation is very easy and there is a common tools kit included in the kit.

LVBU ebike kit can fit most of the bikes on the market, the requirements are as below: The D series motor requirements: The dropout spacing should be above 10 cm and the width of the dropout slots should be above 1 cm. The V series motor requirements: The dropout spacing should be above 8 ...

Lvbu ebike assist system is a special system different from any other systems. The slope of the road is a critical factor in how the system calculates the power that you need. The assist power is highly dependent on the slope. The Gyroscope can measure the slope of the road, but it needs a datum of ...

The installation requirements of the KD/BT (Saddle Bag Battery Ebike Kit) Series controller are as follows: The controller should be placed horizontally, the tilt angle should be within +/- 8 degrees, it will be perfect if you can put it under the bottom bracket;The side of the controller box w...

You can buy a bottle conversion bracket online, so that you can install BY series bottle batteries.

We recommend you to put the battery pack under the saddle. But of course you can also put it in other positions that can attach to the battery firmly.

BTC02 Display Connect Method:Please turn off or disconnect the Bluetooth connection on your phone before the Bluetooth display connects to the LVBU Wheel. The wheel cannot connect to more than one device at the same time; Press the power button of the Bluetooth display to turn it on. ...

We can adjust the clearance between the hub and the fork by adding or removing the spacing washers on both sides. For example, when the caliper hits the hub or the spokes, then we can add the spacing washers between the fork on the caliper side and the hub to enlarge the clearance to avoid the colli...

The side with the brake disc of the motor must be on the left of the bike. The silver mark at the end of the axle must be towards the handle bar of the bike.

There are two brake caliper mounting points on the fork, loosen these two bolts and move the caliper right or left to adjust to obtain a proper clearance, and then tighten the bolts to fix the caliper